Back to Learn
The sectors 7 min read

Upstream: finding and producing

Where the oil and gas actually comes from, how a well is drilled and completed, and why production falls off so fast.

From source rock to reserves

Oil and gas start as ancient organic material buried deep enough that heat and pressure cook it into hydrocarbons over millions of years. That happens in a source rock. In a conventional field, the hydrocarbons then migrate upward until a layer of tight rock traps them in a reservoir you can drill into.

Shale flipped that model. In a shale play, the source rock and the reservoir are the same rock, and the oil is locked in pores far too tight to flow on their own. You have to create the path out. That is what horizontal drilling and hydraulic fracturing do, and it is why the same acreage that was worthless in 1995 became a boom in 2010.

Drilling and completing a well

A modern shale well is drilled straight down for a mile or two, then turned sideways to run along the target rock for another mile or more. That horizontal section, the lateral, is where the production comes from, so longer laterals generally mean more oil per well.

Drilling just makes the hole. Completing the well is the expensive part: pumping water, sand, and chemicals down at high pressure to crack the rock, with the sand holding those cracks open so hydrocarbons can flow back up. A well that is drilled but not yet completed is a DUC, a drilled uncompleted well, and the count of DUCs is a rough gauge of how much production is waiting in the wings.

The decline curve

A shale well produces hard and fast at first, then drops off steeply, often losing more than half its output in the first year. After that the decline flattens into a long, slow tail. Plot that and you get the decline curve, the single most important shape in upstream.

Because each well fades so fast, an E&P has to keep drilling just to hold production flat. That treadmill is why upstream is so capital-hungry, and why the health of an E&P is really a question about its inventory: how many good, undrilled locations does it still have left?

The takeaways

  • Shale is source rock and reservoir in one; you create the flow path by fracking.
  • Drilling makes the hole; completion (the frac) is where much of the cost is.
  • Wells decline fast, so E&Ps must keep drilling to stay flat. Inventory is everything.

Go deeper